Vintage Hafler PRO2400 Stereo Mono Amplifier Fully tested

Description

You are bidding on a high power audio amp. It will drive 400 watts Mono, into an 8 ohm speaker. It was fully tested in both Mono and Stereo modes. It will arrive as advertised to your front door, If you blow this up, it is yours. No returns. Shorting out the speaker outputs will do it. One quirk the power switch is always on. This has no affect on the amplifier functionality
In Mono mode, apply the input to channel B and hook the speaker to the two red terminals. That will get you 400 watts. For Stereo push the Mono/Stereo button to the stereo mode and use normally. Instructions are pictured on the rear panel.
It is heavy and requires a 10 Amp, 110 volt source. Shipping will be a flat to the lower 48 states.
SPECS:
Power output: 120 watts per channel into 8 Ω (stereo), 400 watts into 8Ω (mono)
Frequency response: 10Hz to 40kHz
Total harmonic distortion: 0.02%
Damping factor: 200
Input sensitivity: 2.25V
Signal to noise ratio: 100dB in the lower 48
Dimensions: 5.75 x 19 x 10.5 inches
Weight: 27lbs